Página 80 - abchance

Versión de HTML Básico

Insulated Hand Tool s – 2100
Page 2120
September 2012
Phone: 573-682-5521 Email: hpsliterature@hubbell.com Web: hubbellpowersystems.com
Chuck Blank (
5
8
" opening)
The Chuck Blank can be used for a variety
of applications, such as inserting screw
drivers, saws, etc. The wing nut tightens
the installed tool.
Part No. M445537............................ 5 oz.
Pin Holder
For replacing pins and bolts.
Bolt head fits into a slot
and is held tight by spring
action. Will take bolts or
pins up to 5⁄8" diameter. Fits
EEI and NEMA insulators.
Part No. M44552..........10 oz.
Cutout Tool
While this tool was designed for
removing and replacing the doors of
enclosed cutouts, its finger-like grasp
makes it useful on many other jobs
where a sure grip is required. Jaws
open to accommodate an object
3-3⁄4 “ wide. All parts that contact
porcelain are plastisol covered.
Part No. M44555........................1
3
4
lb.
Ratchet Wrench
1
2
"-square drive
This Ratchet Wrench is used for
tightening bolts in substation
equipment, hardware, transmission and
distribution lines, etc.
Part No. M44556...............................1
3
4
lb.
Disconnect
Used for opening and
closing switches, opening
enclosed cutouts, etc.
Aluminum:
Part No. M44559........2 oz.
Bronze:
Part No. C4001418.....6 oz.
Snapout Cotter
Key Remover
Hammer-like action makes it extremely
useful in pulling out stuck cotter keys.
Release of the compression spring by a
quick jerk of the pole deals
the cotter key a hammer blow
without disengaging the eye.
Part No. M445512.....8 oz.
Locating Pin
Used as a drift pin in aligning
bolt holes as an aid in bolt and
pin insertions. Recommended for
making hardware connections
on tower transmission lines and
line deadends where aligning or
hardware fitting is difficult.
Part No. M445515................. 10 oz.
Fixed Prong
Tie Stick Head
Often preferred for manipulating
tie wires which have looped ends.
Useful in close quarters where loose
ends of tie wire must be rolled up
to prevent contact with crossarm or
hardware while untying.
Part No. M445517.........................1 lb.
Chuck Blank (
5
8
" opening)
Screw drivers, hack saws, and other
tools may be inserted in this device
and secured by soldering. For wingnut
tightened Chuck Blank order No.
M445537.
Part No. M445510................... 4
1
2
oz.
Folding Rule
Adaptable to many uses.
Particularly suited for
obtaining measurements
near live conductors in
congested areas.
Part No. M445516.... 8
1
2
oz.
Universal Tool Accessories
––– See Universal Tool KITS on Page 2119 –––
1
3
8
"